WAGO 890-2112 is a 2-pole, snap-in through-panel plug from the WINSTA® MINI 890 series, coded I, for 1.50 mm² wires, in blue.
Product Model890-2112
Product ID49899
Stock on Request
Last updated: 8/29/2026
Key Features
1
FeatureCompact Design
2
FeatureEasy Installation
3
FeatureClear Coding
4
FeatureDurable Construction
5
FeatureColor-Coded
6
Technical Specifications
Detailed engineering parameters based on manufacturer documentation
Specifications may be subject to change without notice
Parameter
Value
Parameter
Value
Note
The snap-in connectors must be relieved of tensile and transverse forces.A surface finish can influence the edge radius of the cutouts. This may affect the snap-in socket fit, so ensure an adequate fit before use. In addition, the punched edge should be on the inside for punched cutouts.The wings of the snap-in connectors must not be mechanically stressed for a long period before use (e.g., due to a pre-locking position).
Clamping units
2
Total number of potentials
2
Pin spacing
4.4 mm / 0.173 inches
Width
19.8 mm / 0.78 inches
FeatureCompact Design
7
FeatureEasy Installation
8
FeatureClear Coding
9
FeatureDurable Construction
10
FeatureColor-Coded
Height
16 mm / 0.63 inches
Depth
39.85 mm / 1.569 inches
Use
DALI, Lighting Management
Coding
I
Variable coding
No
Marking
- +
Potential Marking
- +
Mating force of a plug-in connection
approx. 20 70 N (depending on pole number)
Retention force of a plug-in connection
Locked: > 80 N
Unmating force of a plug-in connection
Unlocked: approx. 20 70 N (depending on pole number)
Number of mating cycles
200, without resistive load
Housing sheet thickness
0.5 2 mm / 0.02 0.079 inches
Mounting type
Snap-in flange
Protection type
IP20; IP40 when mated
Contact type (pluggable connector)
Male connector/plug
Connector (connection type)
for conductor
Mismating protection
Yes
Note on mismating protection
All WINSTA® components are 100% protected against mismating when:a.) plugging different numbers of polesb.) plugging while rotated 180c.) plugging while laterally staggeredd.) plugging one pole
Locking lever
yes
Locking of plug-in connection
locking lever
Note on locking system
All connectors for mounted installations (snap-in versions for lighting fixtures or devices, all types of PCB and distribution connectors) are factory-equipped with locking levers to ensure plugs and sockets are securely locked. Additional locking levers are only required for flying leads (plug/socket).
Note (material data)
Information on material specifications can be found here
Some versions may also be used for current interruption in accordance with the UL certificate in select applications with currents below 5 A and voltages up to 600 V. For further information, please contact your local sales office.
