221-482

Name: 221-482
Brand: WAGO
SKU: 221-482

Tool-free lever-actuated connector for solid, stranded, and fine-stranded conductors. Easy to use and safe.

Product Model221-482

Product ID47539

Stock on Request

Last updated: 8/29/2026

Quantity

Key Features

1
FeatureTool-free lever-actuated design for easy and quick connections.
2
FeatureCompatible with solid, stranded, and fine-stranded conductors (24–10 AWG).
3
FeatureRated for up to 20 A (UL) and 24.5 A (Ex e II) with 400 V rating.
4
FeatureDurable and transparent housing with light gray actuator.
5
FeatureCompliant with UL, ATEX, and IECEx standards for various applications.

Technical Specifications

Detailed engineering parameters based on manufacturer documentation

Specifications may be subject to change without notice

Parameter

Value

Parameter

Value

Safety management note

NOTICE: Observe installation and safety instructions!Only to be used by electricians!Do not work under voltage/load!Use only for proper use!Observe national regulations/standards/guidelines!Observe technical specifications for the products!Observe the number of permissible potentials!Do not use damaged/dirty components!Observe conductor types, cross-sections and strip lengths!Insert conductor until it hits the product鈥榮 backstop!Use original accessories!To be sold only with installation instructions!

Safety information

The permissible operating voltage of the connector with carrier (440 V or 275 V) depends on the mounting type.

Safety information 2

Only approved in conjunction with a mounting carrier (221-501). Other carriers are possible, see certificate/file. The connectors must be installed in an enclosure meeting the requirements of a recognized protection type per EN 60079-0, GB/T 3836.1 Section 1 or EN 60079-31, GB/T 3836.31. When installing the connectors in an enclosure of protection type 鈥渆(increased safety per EN 60079-7, GB/T 3836.3), the clearances and creepage distances of Table 2 for this standard must be observed. See point 1 for the use of accessories. The connectors can be used both in Group II and Group I, as the standard requirements are identical in this case.The use of these components requires a new assessment by a notified certification agency.