ATV212WD11N4C

Variable speed drive

BACnetMETASYS N2LonWorksModbusAPOGEE FLN

Class C1 EMC filter integrated

17.1 kVA 380 V

24.8 A 60 s

1...10

for DC bus energized 1 LED (red)

Electrical between power and control

VIA, VIB, FM, FLA, FLB, FLC, RY, RC, F, R, RES terminal 0.004 in² (2.5 mm²) / AWG 14L1/R, L2/S, L3/T terminal 0.02 in² (10 mm²) / AWG 6U/T1, V/T2, W/T3 terminal 0.02 in² (16 mm²) / AWG 4

Internal supply for reference potentiometer (1 to 10 kOhm) 10.5 V DC +/- 5 %, <10 A overload and short-circuit protectionInternal supply 24 V DC 21...27 V), <200 A overload and short-circuit protection

FM 2 ms +/- 0.5 ms analogFLA, FLC 7 ms +/- 0.5 ms discreteFLB, FLC 7 ms +/- 0.5 ms discreteRY, RC 7 ms +/- 0.5 ms discrete

VIA +/- 0.15 % of maximum value inputVIB +/- 0.15 % of maximum value inputFM +/- 0.2 % output

Configurable relay logic FLA, FLC) NO - 100000 cyclesConfigurable relay logic FLB, FLC) NC - 100000 cyclesConfigurable relay logic RY, RC) NO - 100000 cycles

5 A 250 V AC resistive cos phi = 1 L/R = 0 ms FL, R)5 A 30 V DC resistive cos phi = 1 L/R = 0 ms FL, R)2 A 250 V AC inductive cos phi = 0.4 L/R = 7 ms FL, R)2 A 30 V DC inductive cos phi = 0.4 L/R = 7 ms FL, R)

Positive logic (source) F, R, RES), <= 5 V, >= 11 VNegative logic (sink) F, R, RES), >= 16 V, <= 10 V

>= 1 mOhm 500 V DC for 1 minute

Monitoring inhibitableWrite single register (06)Time out setting from 0.1 to 100 sWrite multiple registers (16) 2 words maximumRead device identification (43)Read holding registers (03) 2 words maximum

HVAC

2

1

1 RJ451 open style

RTU

8 bits, 1 stop, odd even or no configurable parity

Voltage/frequency ratio, 2 pointsVoltage/frequency ratio - Energy Saving, quadratic U/fFlux vector control without sensor, standardVoltage/frequency ratio, automatic IR compensation (U/f + automatic Uo)Voltage/frequency ratio, 5 points

120 % of nominal motor torque +/- 10 % 60 s

AdjustableNot available in voltage/frequency ratio motor controlAutomatic whatever the load

12 kHz

47.5...63 Hz

Overheating protection driveThermal power stage driveShort-circuit between motor phases driveInput phase breaks driveOvercurrent between output phases and earth driveOvervoltages on the DC bus driveBreak on the control circuit driveAgainst exceeding limit speed driveLine supply overvoltage and undervoltage driveLine supply undervoltage driveAgainst input phase loss driveThermal protection motorMotor phase break motorWith PTC probes motor

22.05 in (560 mm)

80.5 lb(US) (36.5 kg)

1.5 mm 3...13 Hz)IEC 60068-2-61 gn 13...200 Hz)EN/IEC 60068-2-8

Classes 3C1 IEC 60721-3-3Classes 3S2 IEC 60721-3-3

3280.84...9842.52 ft (1000...3000 m) limited to 2000 m for the Corner Grounded distribution network with current derating 1 % per 100 m<= 3280.84 ft (1000 m) without derating

14...104 °F (-10...40 °C) without derating)104...122 °F (40...50 °C) with derating factor)

C-tickNOM 117ULCSA

IEC 61800-3 environments 2 category C1EN 55011 group 1 class BIEC 61800-3 environments 1 category C2IEC 61800-3 environments 2 category C3IEC 61800-3 environments 2 category C2IEC 61800-3 environments 2 category C1IEC 61800-3 environments 1 category C1IEC 61800-5-1IEC 61800-3IEC 61800-3 environments 1 category C2IEC 61800-3 environments 1 category C1IEC 61800-5-1IEC 61800-3 environments 2 category C2EN 61800-3 category C1IEC 61800-3 environments 1 category C3IEC 61800-3 category C1IEC 61800-3 environments 1 category C3IEC 61800-3IEC 61800-3 environments 2 category C3

Electrostatic discharge immunity test level 3 IEC 61000-4-2Radiated radio-frequency electromagnetic field immunity test level 3 IEC 61000-4-3Electrical fast transient/burst immunity test level 4 IEC 61000-4-41.2/50 µs - 8/20 µs surge immunity test level 3 IEC 61000-4-5Conducted radio-frequency immunity test level 3 IEC 61000-4-6Voltage dips and interruptions immunity test IEC 61000-4-11